autronic errors

Dragracer187 · February 6th, 2010, 06:06 PM

I need help with some errors I have.

I get a TPS learn zero error, my value is 0.20v, minimum is set to 0.22 V so I get this error. Can I just lower the value of the warnings or is there something wrong with my TPS sensor?

The other error I get on Launch. See attached pic.

supercharged88 · February 6th, 2010, 08:09 PM

0.2 volts is a low value.
Desired TPS value for closed position is 0.5 volts or higher not exceeding 1 volt.
Try adjusting the TPS voltage higher.
You may have to drill the mounting screw holes out or elongate the holes to allow for adjustment.
Remember to recalibrate the TPS after any adjustments.

Dragracer187 · February 9th, 2010, 12:04 AM

I will measure with a voltmeter to verify and try to get the voltage above 0.5 v. What about the other error?

sss7556 · February 9th, 2010, 05:14 AM

not at range, only

Ian · February 15th, 2010, 02:25 PM

Yellow on the PC screen means an error in the ECU. Red on the PC screen signifies software limit warnings. The limits can be changed by editing parameter limits in menu - Logger - PC Warnings/Log.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

February 6th, 2010, 08:09 PM	#2
supercharged88 Senior Member Join Date: Sep 2008 Location: Cairns, Australia Posts: 175	0.2 volts is a low value. Desired TPS value for closed position is 0.5 volts or higher not exceeding 1 volt. Try adjusting the TPS voltage higher. You may have to drill the mounting screw holes out or elongate the holes to allow for adjustment. Remember to recalibrate the TPS after any adjustments.

February 9th, 2010, 12:04 AM	#3
Dragracer187 Senior Member Join Date: Jun 2008 Location: The Dragstrip Posts: 186	I will measure with a voltmeter to verify and try to get the voltage above 0.5 v. What about the other error?

February 9th, 2010, 05:14 AM	#4
sss7556 Senior Member Join Date: Feb 2008 Location: Novosibirsk, Russia Posts: 114	not at range, only

February 15th, 2010, 02:25 PM	#5
Ian Senior Member Join Date: Feb 2008 Posts: 580	Yellow on the PC screen means an error in the ECU. Red on the PC screen signifies software limit warnings. The limits can be changed by editing parameter limits in menu - Logger - PC Warnings/Log.