MRMRacing

Hello,
Will you be getting anymore Autronic CDI's 500r or HF's anytime soon?
Thanks

Clyde

hello great forum plz i need help with a map for a 2zzge celica engine vvtli

Riktigt snyggt blev den nya sidan. Kul att du hann innan Motorsoffan.

hi
just joined up to the forum. read your post about removing the dwell boards in the smc. i have a 1.94 smc with an AEM CDI ignition and wondering if i need to remove the dwell board in mine?. i have a mate thats an electronics engineer and he could un-solder the board and install the ic for me. what ic would i need? UDN2534B ? and where do i get one ? any help gretly appreciated

regards mitchell

hi MRMRacing. i have a question regarding IAC, bosch, bmw. can you help me? thanks

hej robban ,,,, jo jag missade dig i går kväll 8 snåret , och jag tänkte så här ta,. 6 enkelspolar F1 . CDI R500 och kunde man få ihop en härva mellan CDI och spolarna , då det skulle bara vara att ansluta SM4 tändutgångarna in till CDI kontakten. hängde du me nu L.... vet kan va lite rörigt när jag ska försöka förklara....

Hi Robert was wondering if you had a chance to see if you had the 300zx conector socket for the sm4 ?

Many thanks

Graham

Thanks that would be great !
Is it the pinout diagram from the 300zx ecu that you need ?

Car details are 1992 nissan 300zx twin turbo 2+2 uk spec !

Will try and get a pinout for you

Thanks

Hi there ,



I have some question about tuning a direct injected fuel engine or commerail Diesel engine with Autronic ecu .

I know that you do some great jobs with special engine so i think that i must aks you if this would be possible with a autronic ecu

Would you say to me of this could be done with a ecu or that i need extra hardware to controll the fuel pump or to get a good injector open time .

I could make serveral engine´s if this would be possible but its for tracktor pulling so this would be 7 liter 6 cilinder engine that will run about 1200HP and 3500NM on diesel .
So i need several injector opening time in one cilinder time .

I hope you could say if this could be done or that i need many time of development that i dont have , because these engine are running verry short so i dont have the time to test .

Kind Regards,
Wouter Dijk

Vreedijk-Engineering

the ignitors are built onto the coil