Announcement

Collapse
No announcement yet.

USDM Subaru STI 04-06 cal for non PnP SM4 (1.11)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Both HSI1 and HSI2 reported error and counldn't read the Cam position. Should I increase the Cam error tolerance to ~10deg or is there anything I'm missing?

    Thanks

    Comment


    • #17
      See what the cam positions read with this cal. Again, make sure the cam solenoids are unplugged.
      Attached Files

      Comment


      • #18
        did you get it to work?
        I am following this thread, because I am considering building a new motor which would have 257 heads, and unlike 207 heads they are hall effect sensors with dropping trigger on cams

        besides slight rewiring (2 vs 3 wires for sensors if I recall), I am trying to figure out if this will work with my plugin SM4 1.09

        Comment


        • #19
          Hello Ian,

          This CAL works out and everything run very smooth.

          When the cam solenoids were unplugged, both cams read between approx. 125 deg when the engine warm up. I noticed that both cam angle changed 1-2 deg during warm up, I assumed due to thermo expansion. The only changed was set the cam angle offset to 170 deg.

          Can you show us why set knock cyl offset from 3 to 2? How's this number determine?

          Thanks
          Manuel
          Last edited by evotomcat; November 26th, 2015, 03:25 PM.

          Comment


          • #20
            What cams are those specs for Manuel?

            Comment

            Working...
            X
            okeygabilesohbetdikmen evden eve nakliyatdireksiyon dersifreier pornoFilm porno francaisko cucehttps://www.ko-cuce.net/index.php?forumlar/server-tanitimi.5/ko cucebtc yorumpornohd videoshindi porn videospornhdvideoČeské Porno zdarmajigolokayitci #yaslikurt# Hack haber instagram hackleme sitesi Hack forum