Auquamist with SMC PnP

[boostoman]

I have an evo 7 PnP ECU. I m thinking of getting an aquamist kit for the car. there is a new aquamist system that increases the methanol injection rate as the fuel injector rate is increase (HSF-5) I was wandering if i can setup the ECU to control the aquamist kit.

[gti]

If you use their DDS3 kit, you will not need an ECU to control it.

[Madevelopments]

Fan 2 output can be used for airtemp/pressure and rpm this is now used on the later units to control the water spray, You can also use the boost control output for this also and then run ac if ealier unit based on the on off output.

Mark

[boostoman]

Mark if I use the the Boost control Output would it be able to have a variable rate? Because the system Im looking at is a veriable rate system that piggy backs on the injector signal and as the inject duty cycle increease the spry increase. can I get a 5th injector output from the SMC PNP 1.99 and use it to signal the spray instead of piggy backing a used injector.

[Madevelopments]

You can use the boost output and set mode 5 to 12 from memery it should then use it as a pwm.

Mark