2JZ-GTE idle motor

[Riki]

Hello,
I have -94 Toyota Supra and I bought sm4 to replace the oem ecu. The info I need is how to wire the idle motor. The idle motor has 6 wires so it´s a bit confusing. Should I use all 4 stepper outputs?

http://www.max-boost.co.uk/max-boost/resources/SUPRA_MKIV/Idle_air_control_valve.pdf
Here a wiring diagram of the idle motor

And one more question, Does someone know which one of the two cam sensors should I use?

[MRMRacing]

I am up doing Patch-looms for Supra 89-92 and 93-98. I have the supra connectors with wire sin stock but have not made them ready yet.

The front sensor reads the tooth at almost the same time as the crank sensor reads a tooth on the crankshaft. As they are occurring at the same time you get the sync error.

You use the rear sensor.

I have not done any research regarding IAC yet.

[sss7556]

Hello,
I have -94 Toyota Supra and I bought sm4 to replace the oem ecu. The info I need is how to wire the idle motor. The idle motor has 6 wires so it´s a bit confusing. Should I use all 4 stepper outputs?

http://www.max-boost.co.uk/max-boost/resources/SUPRA_MKIV/Idle_air_control_valve.pdf
Here a wiring diagram of the idle motor

And one more question, Does someone know which one of the two cam sensors should I use?
===
about IAC...early,,,but not good...I used 3 wire bosch valve and I'll try again at April
===
I used one which on the end of block